Ziptie anchor mount
09-04-2023 | 20:00
Bunnykill
NN © 2023
Small ZIPTIE ANCHORs
I was in need of a small ziptie anchor, a mount for a ziptie, but in a place I could not use any screws, since the place was not thick and the other side was supposed to look pretty, so I came up with these small simple things.
They should withstand a lot, but also make sure to use a very good glue when setting them up, so they don't tear off. For bigger applications I would just resize the piece in slicer to appropriate amounts (150+%?)
One is supposed to go on a flat surface (glued on), the other one goes into a corner (glue it, baby)
It's just a simple thing and print settings really depend on the material you choose to use.
I used PLA and printed it on default settings. For my purposes it's fine now.
Printing 10 corner pieces and 10 flat pieces takes about 2 hours total.
(print them laying on side for better performance)
They should withstand a lot, but also make sure to use a very good glue when setting them up, so they don't tear off. For bigger applications I would just resize the piece in slicer to appropriate amounts (150+%?)
Downloads
License
You can use this under the NejedNiko Free Use License - 3D (NFUL-3D) v1.0.
2
0
0
#anchor #cable #corner #flat #glue #ziptie #mount #holder #management
